INSTRUCTIONS FOR TREXLER BALLOON WHEELS

TREXLER BALLOON WHEELS FOR MODEL AIRPLANES CAN BE INFLATED BY THE NEW PATENTED (US#2,206,438)
TUBE ON EACH WHEEL. The wheel and hub are separate, allowing the wheel to be easily removed for repairs. Wheels are made of the finest rubber available.
Because it is so simple a matter to inflate Trexler Balloon Wheels, they are shipped from the factory deflated. This assures full life to the purchaser. Each pair of wheels is packed in an individual box, with size plainly marked, and with instruction sheet enclosed.

TO INFLATE AND DEFLATE:
With each Trexler Balloon Wheel there is a tube attached to inflate and deflate. CARE SHOULD BE TAKEN NOT TO INFLATE THE TREXLER BALLOON WHEELS LARGER THAN THE SIZE STAMPED ON THE CARTON.
After wheel is inflated to correct size, simply wind valve stem around the hub to within 1/2" of the end, then twist and tuck the end between hub and tire. CARE SHOULD BE TAKEN NOT TO GET ANY MOISTURE IN THE TUBE.

TO MAKE WHEELS PERFECTLY ROUND:
Push the large side of the wheel around the hub after inflating.

TO ELIMINATE ANY SIDE WOBBLE:
Push the wheel sideways into proper alignment on the hub.



[ Home | History | Applications | Instructions ]
[ Distributors | Links ]

Last Update 8/18/00